Ramsey-winch RPH-35000 W/ 2 SPEED MOTOR User Manual download pdf (Page 7)

INSTRUCTIONS FOR OVERHAUL

1. Drain oil from gear housing (item #10) by removing plug (item #42) from end bearing. Remove reducer and

relief fitting (items #41 & #36).

If new air cylinder is required,

remove air cylinder (item #32)

from adapter (item #4) by

removing (4) capscrews (item

#23). Remove washer (item

#26), nut and setscrew (items

#27 & #22) and insert (item

#29) from end of air cylinder

rod. Apply Loc-tite to threads of

nut (item #27) and thread onto

setscrew (item #22) to 3/8 inch

from drive end, as shown below.

Apply Loc-tite to threads of

setscrew and thread insert (item

#29) over end of setscrew and

against nut. Use setscrew and

nut to thread insert (item #29)

into end of air cylinder rod.

Tighten nut against cylinder rod, keeping 3/8 inch distance from drive end of setscrew to nut. If breather vent

(item #37) is damaged, remove and replace. Remove air cylinder adapter (item #4) and gasket (item #36)

from gear housing cover by unscrewing (4) capscrews (item #18).

2. Disconnect tube (item #45) from elbow

(item #31) on top of valve (item #46)

and elbow on brake assembly. Remove

motor (item #39) and gasket (item

#35) by removing (2) capscrews (item

#21). Remove valve (item #46), if

needed, from motor by loosening (4)

capscrews.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Ramsey-winch RPH-35000 W/ 2 SPEED MOTOR User Manual Page 7