Ramsey-winch 80K WILDCAT WINCH User Manual download pdf (Page 9)

5. Remove motor #45 from winch by first disconnecting hydraulic lines (see page 17), solenoid

wires, and then remove (4) bolts #73. O-ring #72 may now be removed.

6. Remove brake cover #42 by removing (4) bolts #66. The cover is spring loaded, use care

when removing. Remove o-ring #46 then springs #61 may be removed; residual oil may be

present in the brake housing.

7. Remove piston #11 including o-rings and backup rings #47, #48, #49, and #50 by using a

momentary puff of compressed air into the brake port located on top of the end bearing.

Capture the piston by placing a shop rag over the opening prior to using air.

8. Remove the sprag brake hub assembly #40, (7) stator plates #12, (6) disc brakes #13, and the

spacer #28. The sprag brake hub assembly #40 is not a serviceable part, if damaged a

replacement assembly should be ordered.

7 OM-914207-0211-D

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Ramsey-winch 80K WILDCAT WINCH User Manual Page 9